Oak Herringbone Natural Oiled Drift Wood 15x100x400mm:
Our engineered Parquet Woodblock has been produced using WBP birch ply, manufactured to European standard EN 326-2. The adhesive used to bond the board is an E1 category, PUR adhesive (formaldehyde free) to DIN/EN 14257 and DIN/EN 204 low emission glue which is heat and water resistant in accordance with BS EN 14342:2005+A1. The top layer is kiln dried to between 8-12% moisture content.
The formaldehyde emissions are: 0,01 ppm, pentachlorophenol emissions: <0.8 mg/kg. Thermal conductivity (W/mK) is 0,10W/mK.
Suitable for a fully bonded installation to a screed or ply subfloor, factory Oiled ready to use. *if the product is being laid in a high traffic environment then an additional coat of oil is recommended.
Compatible for use in conjunction with underfloor heating the woodblock complies with BS 8201:2011, rated in accordance with BS EN 13501-1
Product code: OWDRO/400
Species: Oak
Group: Flooring
Category: Solid Flooring
Sub-Category: Parquet Woodblocks
Type of finish: Oiled – An additional coat is recommended.
Brushed: No
Profile: Tongue and Groove
Specification: Bevelled Edge
Weight: 10.6 kg
Recommended Use: Domestic and Light Commercial
Pack Size: 1.6
Dimensions: 400 × 100 × 15 mm
Width: 100 mm
Thickness: 15 mm
Length: 400 mm
Colour : Natural
Under Floor Heating : Yes
Unit Measurement : per Square Metre
Design : Engineered, Parquet & Chevron
Engineered: 2 part Engineered floor with a Hardwood top surface bonded to a multilayer waterproof Birch Plywood. Can be Nailed, Stuck Down, or Floated depending on the sub floor. All floors are Tongue and Groove with Ends Matched unless stated otherwise.
Micro Bevelled: Micro Bevelled means a very small v shape can be seen on the long sides of the boards. The ends have no bevel.
Pre-Oiled: This product is supplied with a Factory UV Oiled surface. The Natural Wood Floor Company recommends that an additional coat of oil is applied to the surface prior to regular use.
Stick Down: Sticking involves the use of an adhesive to bond the wood flooring to either a concrete/screed sub floor or to a ply/chipboard sub floor.
Under Floor Heating: This product is compatible for use over an electric or water under floor heating system. The maximum temperature must not exceed 27 degrees Celsius at the floor surface.
Each wood flooring project is different so an individual approach is a must for us. We've created this cost calculator with this in mind and we hope it will be helpful to you in bringing some much-needed clarity.
Please fill in as many fields as possible with the most accurate and available information. This will increase the quality of the end result.
Please sign in first.
Sign in
