Oak Herringbone Natural Oiled Drift Wood 15x100x400mm
Our engineered Parquet Woodblock has been produced using WBP birch ply, manufactured to European standard EN 326-2. The adhesive used to bond the board is an E1 category, PUR adhesive (formaldehyde free) to DIN/EN 14257 and DIN/EN 204 low emission glue which is heat and water resistant in accordance with BS EN 14342:2005+A1. The top layer is kiln dried to between 8-12% moisture content.
The formaldehyde emissions are: 0,01 ppm, pentachlorophenol emissions: <0.8 mg/kg. Thermal conductivity (W/mK) is 0,10W/mK.
Suitable for a fully bonded installation to a screed or ply subfloor, factory Oiled ready to use. *if the product is being laid in a high traffic environment then an additional coat of oil is recommended.
Compatible for use in conjunction with underfloor heating the woodblock complies with BS 8201:2011, rated in accordance with BS EN 13501-1
Product code: OWDRO/400
Category: Solid Flooring
Sub-Category: Parquet Woodblocks
Type of finish: Oiled – An additional coat is recommended.
Profile: Tongue and Groove
Specification: Bevelled Edge
Weight: 10.6 kg
Recommended Use: Domestic and Light Commercial
Pack Size: 1.6
Dimensions: 400 × 100 × 15 mm
Width: 100 mm
Thickness: 15 mm
Length: 400 mm
Colour : Natural
Under Floor Heating : Yes
Unit Measurement : per Square Metre
Design : Engineered, Parquet & Chevron
Engineered: 2 part Engineered floor with a Hardwood top surface bonded to a multilayer waterproof Birch Plywood. Can be Nailed, Stuck Down, or Floated depending on the sub floor. All floors are Tongue and Groove with Ends Matched unless stated otherwise.
Micro Bevelled: Micro Bevelled means a very small v shape can be seen on the long sides of the boards. The ends have no bevel.
Pre-Oiled: This product is supplied with a Factory UV Oiled surface. The Natural Wood Floor Company recommends that an additional coat of oil is applied to the surface prior to regular use.
Stick Down: Sticking involves the use of an adhesive to bond the wood flooring to either a concrete/screed sub floor or to a ply/chipboard sub floor.
Under Floor Heating: This product is compatible for use over an electric or water under floor heating system. The maximum temperature must not exceed 27 degrees Celsius at the floor surface.