Oak Board Natural Oiled Coastal Grey 20x210mm
Oak Board Natural Oiled Coastal Grey 20x210mm: The beauty of Coastal Grey is that it combines the fashionable shade of grey with warm sandy tones and a weathered, textured surface. The grey coloured oil adds interest by picking up the wood’s distinctive grain patterns and rustic knots, creating a look that’s subtle enough to go with all décor schemes.
This is a versatile floor that will go with almost anything. There’s lots of variation with the colour and grain patterns, so this is a floor that you will never tire of. It will just get better and better over time.
The wide board format is perfect for large open spaces, as generous room proportions will enhance the quality and splendour of this floor’s gorgeous finish.
This engineered oak overlay floor can only be laid over an existing subfloor, not as a structural floor. Overlays are made up of a top layer of precious hardwood with a multi-layer ply backing, meaning this floor has the same beautiful appearance of solid wood but is a much more efficient and sustainable use of material.
Our engineered Parquet Woodblock has been produced using a Russian WBP birch ply, manufactured to European standard EN 326-2. The adhesive used to bond the board is an E1 category, PUR adhesive (formaldehyde free) to DIN/EN 14257 and DIN/EN 204 low emission glue which is heat and water resistant in accordance with BS EN 14342:2005+A1. The top layer is kiln dried to between 8-12% moisture content.
The formaldehyde emissions are: 0,01 ppm, pentachlorophenol emissions: <0.8 mg/kg.
Thermal conductivity (W/mK) is 0,10W/mK.
Suitable for a fully bonded installation to a screed or ply subfloor, factory Oiled ready to use.
*if the product is being laid in a high traffic environment then an additional coat of oil is recommended.
Compatible for use in conjunction with underfloor heating the woodblock complies with BS 8201:2011, rated in accordance with BS EN 13501-1
Product code: OLCGO/210
Category: Engineered Flooring
Sub-Category: Engineered Overlay
Type of finish: Engineered Overlay
Brushed: Millrun Grade, contains knots & Colour variation
Profile: Oiled – An additional coat is recommended.
Weight: 14,3 kg
Recommended Use: per Square Metre
Pack Size: Yes
Dimensions: 210 × 20 mm
Width: 210 mm
Thickness: 20 mm
Colour : Light
Under Floor Heating : Tongue and Groove
Unit Measurement : Bevelled Edge
Design : Wide Boards (150mm – 300mm), Engineered
Engineered: 2 part Engineered floor with a Hardwood top surface bonded to a multilayer waterproof Russian Birch Plywood. Can be Nailed, Stuck Down, or Floated depending on the sub floor. All floors are Tongue and Groove with Ends Matched unless stated otherwise.
Floating: A floating floor is not physically connected to the sub floor. Normally laid on an underlay, the floor is joined by gluing the tongue and groove together or by using a click system.
Micro Bevelled: Micro Bevelled means a very small v shape can be seen on the long sides of the boards. The ends have no bevel.
Nail Fitting: Nail fixing is usually done via a nail gun, e.g. Porta-Nailer, where a serrated nail is inserted through the tongue at 45 degrees.
Pre-Oiled: This product is supplied with a Factory UV Oiled surface. The Natural Wood Floor Company recommends that an additional coat of oil is applied to the surface prior to regular use.
Stick Down: Sticking involves the use of an adhesive to bond the wood flooring to either a concrete/screed sub floor or to a ply/chipboard sub floor.
Under Floor Heating: This product is compatible for use over an electric or water under floor heating system. The maximum temperature must not exceed 27 degrees Celsius at the floor surface.